Non-Contact Voltage Tester Pen, 12-1000 V AC, with Laser Distance Meter

Cat. No.: 
NCVT-6
Product Features
Voltage Tester provides non-contact determination of AC voltage in cables, cords, circuit breakers, switches, outlets and wires, as well as AC voltage in security, entertainment, communications, environmental control and irrigation systems
Volt Pen detects AC voltage from 12 to 1000 V with visual and audible indicators
Incorporates a 66' (20 m) Laser Distance Meter that can measure in metres, inches with decimals, inches with fractions, feet with decimals, or feet with fractions
High-visibility reverse contrast display for better viewing in low light conditions
Laser Class II, 630 nm to 670 nm, Max. Power <1 mW
Simple-to-use intuitive interface; easy single-button changes between laser distance measurements and voltage detection
Delivers simultaneous visual and audible voltage indicators when AC voltage is detected
Audible voltage indicator beeps at a greater frequency the higher the voltage that is sensed, or the closer to the voltage source
Built to withstand a 6.6' (2 m) drop
Auto Power-Off conserves and extends battery life
Screw-thread battery cap
Lightweight tool with pocket clip for easy everyday carrying and storage
CAT IV 1000V safety rating
Ingress Protection IP40 Dust Resistant
Specifications
Type:
Non-Contact Voltage Tester
Application:
Non-Contact Detection and Testing of the AC Voltage with an Integrated Laser Distance Meter
Special Features:
Full-Range Voltage Detection From 12-1000 VAC with Visual and Audible Indicators; Laser Distance Meter; High Visibility Reverse Contrast Display
Material:
Plastic and electronic assemblies
Drop Protection:
6.6' (2 m)
Voltage:
12-1000 VAC
Frequency:
50-500 Hz
Pollution Degree:
2
Ingress protection:
IP40 Dust Resistant
Standard:
CAT IV 1000 V; Laser: Class II, 630 nm to 670 nm, Max. Power <1 mW
Included:
2 x Alkaline 1.5V AAA Batteries
Batteries:
2 x AAA
Overall Length:
6.45'' (16.4 cm)
Overall Height:
1.21'' (3.1 cm)
Overall Width:
1.32'' (3.4 cm)
Weight:
2.5 oz (72 g)
Videos

Downloads
Warnings
Read, understand and follow all instructions, cautions and warnings attached to and/or packed with all test and measurement devices before each use.
Never assume that neutral or ground wires are not live. Neutrals in multi-wire branch circuits may be energised when disconnected and must be retested before handling.
LASER RADIATION, Class II laser. DO NOT direct the laser beam into eyes, DO NOT stare into the beam and DO NOT view directly with optical instruments, as this can cause severe and permanent eye damage.
Always adhere to local and national safety codes. Use personal protective equipment to prevent shock and arc blast injury where hazardous live conductors are exposed.
Use of this tester in any way other than that specified by the manufacturer can impair safe operations, resulting in severe injury or death.